| 3D Printing Room Precautions apply
|
|
You will be working in the 3D Printing Room . In order to keep safe from hazards created by you or other workers using any of the tools in this room, the following precautions apply in addition to any other precautions:
- In general, it's a good idea to watch your print until the first few layers are complete. 3D printing can be somewhat unreliable and prints often fail over the first few layers.
- SLA resin is very messy and poses several hazards that can accumulate over time. If you're working near the resin printers, do not touch your face or eyes and wash your hands afterwards.
- If you're working with the resin printers, wear protective nitrile gloves (available at the cleaning workstation). When pouring resin, wear goggles (with complete face seal) to avoid splashback injury.
- If you get resin on your skin, wash thoroughly with soap and water
- If you get resin in your eyes, flush thoroughly with the eye wash solution
- Wear safety glasses when removing snapaway supports.
- SDS are available in the SDS Binder near the door.
- Always label your filament rolls with your full name. Unlabelled rolls will be considered community use.
- Put finished prints in the finished prints bin.
- If you need to unload someone else's filament, please tuck in the ends to avoid tangling.
|
Instructions:Filament Warmer/Dryer doesn't exist yet
North Forge has two DIY filament dryers. If you haven't stored your filament properly, it can absorb moisture and cause poor print quality. The filament dryer will remove the moisture.
Dry your PLA at 113F for 8 hours before printing. Other materials may require hotter temperatures or shorter times. Please don't leave your filament in the dryer long-term.
