Editing Instructions:Router Table

===Purpose===
The router table has a table with a rotating tool pointing up through a hole in the table. It is used for cutting and shaping wood in many different ways:

*Slots
*Chamfered or filleted edges
*Cutting complex joinery
*Moulding


===Safety===
'''Do''':
*Use a fixture or sled wherever possible

'''Do not''':
*Feed with the rotation of the tool (left to right, when standing in front of the table)

*Let hands come within 6” of the tool - use push blocks where required


===Tool changes===
#Unplug the router and lower before changing tools.
#Insert the collet wrenches against the collet nut. Keep the wrenches close together for ease of use.
#Using one hand, squeeze the wrenches together to loosen the collet nut.
#Install the tool, using an adapter if required. Ensure tool is fully inserted.
#Replace the collet and tool into the router.
#Squeeze the wrenches together to tighten the nut.



===Operation===
#Check that the correct throat plate is installed (use the smallest possible plate to minimize gaps between tool and table)
#Select the appropriate speed range:
##Large tools (above ¾”) = SLOW
##Small tools (¾” or below) = FAST
#Ensure the fence is in position and locked.
#Set the tool height as required. Rule of thumb: depth of cut = 1/2x tool diameter 

===Shutdown and Housekeeping===
*Remove all workpieces, tools, and fixtures
*Store collet adapter on the rack with wrenches and crank handle
*Store push blocks on the peg board 
*Store clamps on the wood room rack, wood room peg board, CNC room peg board, or tool room (small clamps only)
*Wipe exterior with a brush (table, handles)
*Remove dust collector hose and check for debris/clogs (replace when done)
*Sweep floor around router table, small band saw



Tips and tricks:

*To check if the bit is dull, run your fingernail along the edge. If it catches, the bit is sharp. If it slides along smoothly, the bit is dull and should be replaced.

*General rule of thumb: the depth of cut should be half of the diameter of the tool. For example, a 1/4" tool would have a max depth of cut of 1/8". Deeper cuts can be done in multiple passes.