Editing Instructions:Roland TrueVIS VG3-540 Printer

'''Do not use the Roland unless you have had [[Roland Printer Training]]. ''' This is just a checklist.

== Prep file ==
* open in [[CorelDraw]]
* set the vector that is the cut-out for the decal and backing to Contour cut
* set the vector that is the cut for the decal on top of the backing to Perf contour cut
* save as .pdf file with your name as part of the file name

== Setting up roll of vinyl ==
* see details in instructions on the bucket
* make sure rollers are up
* push through media until 1 beep and then 2 beeps; fan should come on to hold it down
* lower rollers
* slide the side clamps onto the vinyl until the edge shows in the holes
* click "setup" button on screen on Roland
* click the material you are using (if not plain shiny vinyl, check the canonical instructions, wherever they are)
* it should say ready to print or something similar after that

== Sending the print job ==
* open [[VersaWorks]] on the [[Roland PC]]
* drag the .pdf file into the file list on the left
* click the printer button
* the PC will take some time to process and print the file

== Shut-down ==

* lift the rollers
* wind the vinyl back onto the roll
{{Discuss | 
Just a note from using it today. I could not find any instructions for it around to remind me of the details. [[User:Ttenbergen|Ttenbergen]] ([[User talk:Ttenbergen|talk]]) 23:18, 2024 October 27 (CDT)
}}