Editing Instructions:Laguna Bandsaw


== Purpose ==
The band saw has a vertical blade. It is used for:

* Ripping rough lumber that does not fit on the jointer
* Cutting freehand curves (limited by the depth of the blade)
* Resawing (cutting boards to different thicknesses)

The Laguna bandsaw is equipped with a carbide blade and can be used for resawing; the carbide blade must be de-tensioned after use to prevent warping.

== Safety ==
Do:

* Check that the fence is square if required
* Make sure the blade on the large band saw is tensioned before use and de-tensioned after use
* Lower the guard so it is close to the workpiece before starting
* Ensure the blade is fully stopped before leaving the area
* Check beside the blade for trapped debris when done

'''Do not:'''

* Cut round workpieces without a sled or fixture
* Attempt to change the blade without prior training
* Let fingers come close to the blade - use a push stick if required, especially at the end of cuts
* Leave the equipment while the blade is still moving - the band saw blade takes a long time to slow down without the brake
* Use excessive force - let the blade do the work
* Continue working if you notice sparks from the guard - you may be pressing too hard, or the guard guides may need to be adjusted

=== Emergency Stop ===
The band saw can be stopped by pressing the stop button and applying the foot brake (on the right side of the equipment).

== Operating Procedure ==

# Remove the clamp and tension sign from the blade. {{Discuss|Do we want to include instructions on where to put the sign to maximize chances of re-applying it and remembering to untension? }}
# Apply tension to the blade using the tension lever.
# Set the blade guard to slightly above the height of the workpiece.
# Set the fence if required - note that fence may not be square by default and may require shims. Consult trainer or manual for assistance.
# Prepare any safety devices (featherboard, push blocks, sleds for round pieces etc)
# Carefully feed the material through the saw, letting the blade do the work.

[[File:Band Saw Tensioning V2a.jpg|thumb|400x400px|left]]
<div style="clear: both"></div>

== Shutdown and Housekeeping ==

* Remove and store fixtures and safety devices
** Featherboards and push sticks are stored on the wood room peg board, and some with magnets on the top of the body of the band saw.
* Wipe outside of saw (table, fence, handles) with a brush
* Check dust collector tube for debris/clogs
* De-tension the blade and clamp the warning sign to it. The blade can be damaged if you do not de-tension it.
* Sweep the floor around the band saw, miter saw, and table saw
* Turn off the equipment and dust collector
* Turn off the main exhaust if you are the last one in the room
** Turning off the exhaust will turn off all equipment in the room.