Editing Instructions:Large Finishing Tumbler (section)

== '''Troubleshooting:''' ==
{| class="wikitable"
|'''Issue'''
|'''Possible Cause'''
|'''Possible Solution''' 
|-
|Water not flowing into tank
|Pump Motor Plugged
|Remove pump inlet filter, and unscrew the plastic housing (3 screws). 

Remove the housing and clean any residue that may be causing the pump not to spin.
{{Discuss | 
* we don't generally allow member maintenance; does the fablab approve this exception}}

Reinstall housing and test
|-
|
|Outflow pipe clogged
|The water outflows out of several small holes in the pipe. These holes are indicated with black lines. Use a screwdriver or pointed tool to clean the holes out.
|-
|Machine not turning on
|Breaker is tripped
|Reset the breaker at the pane, in the rented spaces near the machining area
{{Discuss | 
* is this a common problem? If so we need to address that. And we need more detailed instructions on which braker. 
}}
|-
|
|Motor is overheated
|Allow to cool for 30 minutes and try again
{{Discuss | 
* is this a common problem? If so we need to address that. 
}}
|}