Editing Instructions:Big Blue Laser (section)

=== Overview ===

# Check the debris tray and empty if needed (lift up the grid panels to avoid having to take out the entire bed).
# Turn on the laser.
# Clean the lens (at the beginning of your session).
# Load the material.
# Set the laser focus and home point.
# Assign appropriate speed and power settings for the material type and thickness.
# Send the print job to the laser.
# Verify that the blast gates are open and air support is turned on.
# Turn on the exhaust vacuum.
# Close the lid.
# Press GO to begin the job.
# Monitor the job carefully, especially during vector operations.
# Check the lens every 1-2 hours and clean if needed.