Editing Instructions:Reflow oven (section)

== Oven Preparation ==
[[File:ProtoFlowS-Front.jpg|thumb]]
[[File:ProtoFlowS-Panel.jpg|thumb]]
* Turn on the oven by pressing the grey power button on the front of the unit.
* Watch the display on the top of the unit. Once the words "SELECT PROFILE SETTINGS" show, it has finished booting. Press the down arrow twice to get to the OPEN/CLOSE menu item, then press the right arrow to select it. The door will open.
* Put on your heat-resistant gloves.
* There are three PCB holders that slide on two rails. Slide two of the PCB holders (or all three if you have more than one row of boards to do) so that your PCB is centered over top of one or both of the fans. The PCB should rest on the flat part of the holders, not on top of them.
* [[File:ProtoFlowS-Open.jpg|thumb]]Once you are happy with the placement of the holders, remove your PCB and press the right arrow on the panel to close the door.