Editing Instructions:ShopBot 3-Axis CNC Mill (section)

=== Vacuum Table ===
Begin wearing respiratory protection and hearing protection at this point.

1. Clean the table of debris first using a broom, then using compressed air. Debris can affect the accuracy of the final part.

[[File:Nf11cleanload48cleanup.jpg|thumb|200x200px|left|Clean the table]]
<div style="clear: both"></div>

2. Open all valves on the vacuum table (OPEN = valve handle parallel to pipe)

[[File:Nf10vacuum12valveopen.jpg|thumb|200x200px|left|Vacuum table]]
<div style="clear: both"></div>

3. Turn on the vacuum table using the remote outside the room.

[[File:Nf13vacuumon.jpg|thumb|200x200px|left|Vacuum remote]]
<div style="clear: both"></div>

4. Close the BYPASS valve (middle) and any unused zones.

[[File:Nf14bypass.jpg|thumb|200x200px|left|Byass valve]]
<div style="clear: both"></div>

5. Check the hold by pressing horizontally on the secondary  spoilboard or workpiece.