Editing Instructions:Little Blue Laser (Epilog Helix 8000) (section)

==== Raster Problems ====
When using raster mode, high speeds will cause the motors to wear out prematurely. North Forge policy is to keep speed below 80%. Note that the existing tables may suggest speeds above 80%; in that case you will need to adjust them manually:

# Find the recommended values in the speed/power table
# If the suggested raster speed is greater than 80%, set the speed to 80%.
# Subtract the same percentage from the power as you did for the speed. For example, if the recommended speed/power is 100/80, subtract 20 points from the speed to get to 80 and 20 points from the power to get 60. The adjusted speed/power is 80/60.
# If the suggested power is already less than 20 points, set the power to 5 and the speed as close to 80% as possible. For example, if the recommended speed/power is 100/15, the adjusted speed/power is 90/5.