Editing Instructions:Heat Press (section)

==== Hat Press ====
The Hat/Part Heat Press can be used to press items where you don’t want the whole item to be heated up, or where you would not be able to get a flat part if you put it on the Flat Heat Press. The presser pad can be removed from the machine to better position items like sleeves (slides forwards and out).

# Put the fabric on the soft pad of the heat press you will use; put the removable part back in the heat press if applicable. 
# Place the HTV or sublimation paper on the fabric face down.
## Make sure you get this right or you will make a mess! HTV needs to have the shiny side up.
# Protect the heat plate: put a piece of paper / parchment paper over top of the HTV or sublimation paper to protect the heat plate so nothing get stuck to it; you can find paper in the paper printer in the corner of the room (not sublimation paper!)
# Push down on the handle to close it; keep pushing until you are over the cam and it stays closed, that way you will have the right pressure. You will have to push fairly hard to close the flat press.
# Press the down arrow button to start the timer
# Once the timer finishes the press will beep; open the press all the way
## Be careful: if you let go of the handle before the Heat Press is fully open, it will spring open with a lot of force that might be enough to move the whole machine.
# Remove the item from the heat press carefully and let the item cool to room temperature.
# Carefully remove the backing paper of the HTV or the sublimation paper.