Editing Instructions:Formlabs Form 2 Resin 3D Printer (LovingCosset) (section)

===Using the Printer===
====Changing Resin====
This section needs a photo showing the position of the wiper when storing the tank.

It is important to filter the resin when changing it, to prevent partly cured resin/debris from clogging the fill nipple.

Removing tank and cartridge
# Put on PPE (gloves, goggles).
# Remove the build plate to avoid dripping resin inside the printer.
# Remove the cartridge and unscrew the cap.
# Load a cone filter and funnel into the cartridge neck. Set aside.
# Pull the wiper towards the front of the tank and lift upwards to remove. Rest the wiper against the edge of the tank.
# Holding from the sides, pull the tank towards you and lift upwards. Do not touch the bottom of the tank.
# Using the fill spout at the back of the tank, pour the excess resin through the filter and back into the cartridge.
# Using gloved hands or a plastic scraper, remove any remaining debris and discard.
# Remove the funnel and discard the cone filter. Replace the cap.
# With the wiper resting against the right side of the tank, put a plastic cover on the tank.
# Put the tank and cartridge in the appropriate labelled plastic bin.
'''Installing'''

# Put on PPE (goggles, gloves)
# Remove the plastic cover from the tank and place it in the plastic bin.
# Align the tabs on the bottom of the tank with the keyhole slots in the platen.
# Push the tank towards the back of the printer. The printer should automatically recognize the tank and show a "Tank inserted" message.
# Align the tab on the bottom of the wiper with the keyhole slot on the wiper arm. 
# Push the wiper towards the back of the printer.
# Insert the cartridge into the back of the printer.
# Open the cartridge vent.

====Starting a Print====
====Cleaning a Print====
====Curing a Print====