Editing Instructions:Big Blue Laser (section)

==== Raster Speed Problems ====


Running small rasters at high speed can damage the belts and motors. If you are rastering parts less than 4" across, you will need to adjust the raster speed and power to prevent damage:

# Find the recommended values in the speed/power table
# Set the raster speed to less than 50%
# Subtract the same percentage from the power as you did for the speed. For example, if the recommended speed/power is 100/80, subtract 60 points from the speed to get to 50 and 60 points from the power to get 20. The adjusted speed/power is 40/20.