Editing Instructions:Safety Speed Panel Saw

{{Discuss|
* this still needs SWPs etc, I am just adding some observations from today
* the saw portion can tilt to a horizontal position. Is there any safe or reasonable way to use it that way? }}

* when cutting vertically, make sure that the remaining portions of the sheet will remain fully supported. If you cut e.g. 1ft of an 8ft sheet the remaining 7ft section may drop off unconctolled, damaging your sheet and creating a hazard. 

* Due to changes in tool position, this tool is not currently interlocked with its dust collector. Dust collection is via the [[Dust extractor (CWI) wide belt sander]] but interlocking is from the [[Dust extractor (CWI) table saw]]. You need to turn on both to use the panel saw.